Page 1 of 1
How to get power cable through firewall??
Posted: Sat Jul 16, 2011 8:56 am
by will2k
Hey everyone i can't figure out how to get my 4 guage power wire though the firewall so i can connect it to my amp. There isn't many rubber grommets and they all look full.
Any ideas?
Re: How to get power cable through firewall??
Posted: Sat Jul 16, 2011 3:34 pm
by kdkiz
I ran mine on the drivers side of the fire wall.I made i small hole in the side of the boot with a coat hanger all the way through in to the car under the dash,taped the end of the wire to the hanger end and had my son pulled as I pushed it in.It made a nice tight seal.Be careful you dont poke any wire's,go slow and take your time.
Re: How to get power cable through firewall??
Posted: Sun Jul 17, 2011 8:51 am
by will2k
Is that the grey rubber grommet behind the battery?
On my car it would be the passenger side, should be more room there since there's no pedals so i'll give it a go next weekend thankyou!
Re: How to get power cable through firewall??
Posted: Mon Jul 18, 2011 1:29 am
by kdkiz
Yes it behind the battery and down a bit.No problem,glad I could help.
Re: How to get power cable through firewall??
Posted: Tue Jul 19, 2011 1:59 am
by will2k
I thought that was the bastard! Thankyou very much, you are the man!
I will remove the battery to have more room and give it a go in a few days.
It's been the only thing setting me back at the moment.
Re: How to get power cable through firewall??
Posted: Thu Jul 21, 2011 2:12 am
by kdkiz
No problem.Any time.