Kizashi Club

Dumb question here.....

I've just licensed my new Kizashi....the trunk has your basic screw holes to connect the license plate. The front has no pre-existing frame or "holes". I do see 4 indent marks on the front bumper and I'm assuming they line up to properly insert the screws....but before I begin doing that....my question is....do all Kizashi's have this same setup or am I missing a frame that is supposed to be there?

waiter wrote:Dumb question here.....

I've just licensed my new Kizashi....the trunk has your basic screw holes to connect the license plate. The front has no pre-existing frame or "holes". I do see 4 indent marks on the front bumper and I'm assuming they line up to properly insert the screws....but before I begin doing that....my question is....do all Kizashi's have this same setup or am I missing a frame that is supposed to be there?

If there's a bracket the dealer should have provided it. I have a front plate too however the dealership installed my plates when I bought it and I've never really paid attention.
To answer your question, yes the indents are for the plate installation.

Did you buy your car in a different state than you registered it in?

Yes bought it in a different state...then were it was licensed.

Gotcha. I'd ask them for a bracket, or ask a Suzuki dealer in your state for one.

Just use some self tapping screws and attach. I put my blue line plate on the front of mine.