6.6 liters is total. There is still some coolant trapped in block and heater core. Had your car gone above normal operating temp that you can remember ?

I have seen this more than a few times . It usually happens when engine has been over heated by a loss of coolant or the drive belt gets rolled off by a faulty belt tensioner. it will be fine to leave that piece in there. The direction of the flow of coolant will trap it in the top of the radiator. ...

Im not so sure you sure should through in the towel at this point. The head can be removed in the car and its fairly easy as far as todays engines go. The cyl head can be gotten used at $300 . Total job $1300, or less if your head is salvageable. Engine replacement could be done at $1800. Add anothe...

That is a sad story. Anyhow the new problem you have , lets try and figure what you have. Im suspecting the overheat was a bit severe and that now there is a loss of compression. How does the radiator cap look? how does the radiator look where the cap seats ? Is there a smell of unburned fuel in rad...

There is none..What problems are you having and when did it start ? Any codes?

My guess is debris landed on hot wire of mas and reading skewed enough to interrupt the normal perfect running but not enough or long enough to set a code. Engine data with scan tool is the only way to confirm that but would of had to be connected while it was happening. I would clean mas . blow out...

It sounds like you’re in good hands. I do think that what is needed to be tried is four original sensors and the easiest way to do that would be to borrow four wheels off of another working car. That way, no expense is put out there unnecessarily. I wish you were closer I would love to help you get ...

I've seen alot of this. Its only on the standard inside rear view mirrors. I was wanting to try a mirror off a Honda or Dodge. The Kizashi mounting tab looks the same as theirs.

Well I received my 3 sets of these copy sensors and registered two of them and no problem until you drive 2 miles and the tire light started flashing twice every 2 seconds. They report temp and pressure perfectly but must be missing an internal marker the looking car is for on some of these. The fir...

The tire pressure monitor sensors that I steered you into, worked for me but yet I only had purchased one set of four which I used two of them on separate cars and they worked fine. I’m thinking that they may in question right now. The proper replacement through continental would be SE10001HP. Found...