Feeler: Wilwood 350/330mm Brake Setup
Posted: Sun Feb 21, 2016 4:54 pm
I should likely leave well enough alone (this really did turn out stellar for me), but my desire to constantly change things is tough to suppress. Depending on the demand for my old setup, which is pictured, I might try to do this again. Any interest in my current setup if the price point were around $1K?
The skinny on the hardware:
E-mail me to discuss.
The skinny on the hardware:
- - Superlite FSLI front, FNDL rear calipers (Cleared with urethane which makes all the difference in keeping them looking shiny and clean - and keeping caustic cleaners from attacking the aluminum).
- 350mm fronts and 330mm rear rotors (about 10K miles). (I can dimple them prior to shipping if you dig that look)
- EBD RedStuff (ceramic) pads all round (PITA to obtain).
- AN4 lines (Kevlar), fittings (AN4) and adapters (M10INV to AN4) included.
- All brackets included.
- All additional bolts/spacers included.
- - Increased the rotor dia 50mm at each corner
- Decreased weight by some 4-6lbs (total)
- Overall piston/rotor bias maintained (+/-3%) to keep OE performance/safety intact (or close).
**NOTE: This swap will render your e-brake useless.**
E-mail me to discuss.